Become a tiling master with Smart Stone using our detailed instructions and expert advice.
By using Smart Stone, you get not only high-quality material, but also the assurance that it will serve for a long time and look perfect in your home project. We are happy to share our experience and knowledge so that your home can truly flourish.
The base should be cleaned (if necessary) and coated with a primer using a brush or roller.
Using a level and a reference cord, mark horizontal lines on the wall.
Mix the tile adhesive.
Using a notched trowel, apply the adhesive to the wall.
Do not apply adhesive to the material.
Place the "SMART STONE" material on the adhesive.
Properly position the tile, pressing slightly for fixation.
Use a knife and ruler for trimming.
Using a pressing float or a rubber roller, press the tile to allow the adhesive to extrude from the joints.
Seal the joints between the "SMART STONE" tiles.
If necessary, add adhesive to the joints.
Seal small joints with a spatula and larger joints with your fingers.
Using a sponge and water, carefully remove all excess adhesive from the tile and joints.
Clean the laid area several times with clean water immediately after sealing the joints.
 2 plastic buckets |
 Mixer |
 10 cm spatula |
 Toothed trowel (6 mm or 4 mm) |
 Utility knife and blades |
 Metal ruler |
 Furred roller |
 Brush |
 Tape measure |
 Pressing float |
 Rubber pressing roller |
 Sponge |
 Gloves |
 Rubber gloves |
 Level / laser level |
 Reference cord |
